Description
Specifications
| Product Code | YVFO |
| Product Type | Spinal wedge bolster |
| Shape | 45-degree wedge bolster |
| Dimensions | 21 x 7 x 7 inches (L x W x H) |
| Material | High-density foam, vinyl-covered |
| Cover | Royal blue reinforced vinyl, sewn seams |
| Surface | Non-porous, tear-resistant, fluid-resistant |
| Radiolucent | No (seams show in imaging) |
| Latex Free | Yes |
| Made In | United States |
| Category | Positioning Sponges |
Where the YVFO Vinyl Covered 45 Degree Spinal Wedge Bolster Sponge Fits
This bolster is the standard, vinyl-wrapped version of the 45-degree spinal wedge, built for positioning and patient comfort rather than imaging through the foam. Lay it along the back to hold a patient on their side, or set it under the torso to raise one side into a 45-degree tilt and hold it there. The 21-inch length spreads the support from the shoulder to the hip, so the patient does not sink into a gap.
Two things to weigh as you choose: it is not rated for the MRI suite, so if you need a bolster for MR, the MR-safe version has the same shape and MR verification. And the vinyl seams show in imaging, so when the bolster sits in the beam, and the image needs to stay clear, the closed-cell spinal wedge gives you the same 45-degree angle in non-coated, radiolucent foam.
Built to Hold Up
- Vinyl wrapped foam holds the body on its side at a steady 45-degree tilt across 21 inches.
- High-density foam carries the weight without sagging in the middle.
- Royal blue reinforced vinyl wipes clean and resists tears, so it stands up to daily use.
- Fully sewn seams seal the cover, so fluid stays on the surface and the foam stays dry.
- Latex-free, so it suits patients and staff with a latex sensitivity.
- Lighter on the budget than the MR safe version, for rooms that do not need MR.
Cleaning and Care
Clean the vinyl with cold water and a mild detergent right after any contact with fluid. A disinfectant wipe handles routine cleaning, with a few minutes of dry time before the next patient. Skip harsh solvents and do not soak, launder, or autoclave the bolster, since that shortens the life of the vinyl and can discolor the surface. Store it clean and dry with the rest of your positioning sponges so the wedge keeps its shape.
Frequently Asked Questions
What is the spinal wedge bolster used for?
It holds the body on its side at a 45-degree angle for support and comfort during a procedure. At 21 inches, it runs from the shoulder to the hip, so the patient does not sink into a gap the way a short wedge would allow.
Is it MR safe?
No. This is the standard version and is not rated for the MRI suite. For MR work, choose the MR safe version, which carries the same shape as the MR verification.
Is it radiolucent?
No. The vinyl cover and its sewn seams show up in imaging. When the bolster sits in the beam, and the image needs to stay clear, choose a non-coated closed-cell version.
How do you clean the vinyl cover?
Wipe it with a disinfectant wipe, or clean off fluid with cold water and a mild detergent. Do not soak, launder, or autoclave it.
What size and angle is it?
It is a 45-degree wedge bolster measuring 21 by 7 by 7 inches, built to support the length of the body.
